New RA0SMS mini-whip antenna on the roof. The old one lasted from 2017/02 to 2018/10.
Category: Electronics
ONET1191P
ONET1191P, Limiting amplifier for up to 11 Gbps.
THS3491
THS3491 looks like an interesting op-amp for distribution amplifiers and in general for LF/HF work. However it turns out it is a bit finicky about the feedback resistors (high resistance values are stable but noisy, low values would give low noise but might be unstable). We're sticking with LMH6702 for now..
HMC394 2.2 GHz prescaler
HMC394 is a 2.2 GHz programmable prescaler (5-bit counter) with divide-ratios from /2 to /32.
SMA-to-SFP frequency stability
Some old plots from 2017 of the residual phase-noise at 10MHz when the signal is fed through an SMA-to-SFP board, SFP to optical, 2m optical fibre, then SFP back to electrical, and another SFP-to-SMA board.
One version of the board is on github: https://github.com/aewallin/SFP2SMA_2018.03
As a comparison the noise-floor of the 3120A and a frequency distribution amplifier is also shown.
AD9912
DDS with 47-bit tuneable frequency word.
LFSCP-64-1EP footprint
AD CP-64-7 footprint using https://github.com/pointhi/kicad-footprint-generator
USB 2 hub
"industry grade" USB-hub containing FE2.1 USB hub chip.
TO-263 Heatsink, Fischer
Have been using this SMD heatsink for (among others) TO-263 voltage regulators, e.g. LT1963 and LT3015.
https://www.fischerelektronik.de/pim/upload/fischerData/cadpdf/base/fk_244_13_d2_pak.pdf
Mini-Circuits footprints
These 'plain' footprints correspond to the "land-pattern" footprints created previously. No GND-pads or GND-vias in these.